Haro Montreal
Montreal 15 is the cost-saving alternative of model Montreal 21 featuring a load distribution module made of OSB boards instead of plywood (model Montreal 21). OSB (Oriented strand board) boards are engineered, mat-formed panel products. They are made of strands and flakes sliced from small diameters, round wood logs and bonded with an exterior-type binder under heat and pressure. The performance of both models is equal, as both exceed the requirements of German DIN V 18032, part II and provide a unique performance. What is even better is that the installation is incredibly fast. Model Montreal 15 features the HARO module technology – this means that the most time consuming assembly part has already been done in the HARO factory. Model Montreal consists of two components - the HARO elastic layer and the HARO load distribution modules. The elastic layer is laid out loosely in the entire hall, the 2.50m x 1.25m (8’ 2’’ x 4’ 1’’) load distribution modules are installed on top and screwed together. A High-speed installation.Model Montreal must be installed on an even sub-floor. The slab should be level according to DIN 18032, part II and DIN 18202:1997-04, figure 3 (compare with “PART 1 – GENERAL” 1.1 Tolerances).
The construction height of Montreal 15 is just 39mm and therefore a perfect choice for renovations. Montreal 15 fully meets the requirements of German DIN standard 18032-2 and is officially approved by the International Basketball Association (FIBA) for second level competitions.